Only the finest materials are used in the manufacturing process of all of our fashion jewelry products. 

Our rings contain pure jewelers bronze or sterling silver as a base metal. Other fashion jewelry manufacturers may use brass as a base core metal.  We have used both and both are good; but when manufacturing fashion jewelry we have found that the pure jewelers bronze and sterling silver is superior in all ways that will enhance the beauty and wear ability of your fashion jewelry. Even though its initial cost is greater, cost has never been our prime concern.  Customer satisfaction is and always will be our greatest concern. Our rings are finished by using a permanent heat bonded finish, either 14k yellow gold, white gold, platinum, or non-tarnishing rhodium.

Our sterling silver rings contain genuine .925 sterling silver.

All cubic zirconia stones used are Russian Formula cubic zirconias. These are the finest man made and laboratory created stones.  Of the five classes of cubic zirconia, the Russian Formula cubic zirconias are the finest and never lose their luster, brilliance or color.  For nearly four decades the Russian Formula CZ stones have set the world wide standard for brilliance, cut and clarity.

All crystal stones used are genuine Swarovski Austrian Crystal.  Since 1842 Swarovski Austrian Crystals have been acknowledged as the worlds finest, in brilliance, cut and clarity.

We are proud to offer an unconditional lifetime warranty on all of our jewelry products.  One lifetime warranty will be shipped along with each item that you purchase.

Jewelry Care

It is not hard to beautifully maintain your fashion jewelry pieces.  With the exception of the watches, the following steps should help to ensure that your fashion jewelry pieces will last for years to come.

1. Immerse the jewelry for 8-10 seconds in any good liquid gold or silver cleaner.
   (Do not leave the jewelry in any longer than 10 seconds)
2. Rinse the jewelry clean under a warm water faucet.
3. Rinse the jewelry once again in a separate glass or plastic container in a mild soapy water solution.
4. Thoroughly rinse the jewelry again under the warm water faucet.
5. Dry your jewelry with a towel and leave on the towel…
6. Blow dry the jewelry with your hair dryer, be sure to dry under and around the stones. (Caution do not hold the jewelry while blow drying IT WILL BE VERY HOT and do wait for the jewelry to cool off before putting it back on)

The result is beautiful. All water (except certain bottled waters) contain many minerals that when allowed to air dry will deposit a tiny residue on the surface that will eventually dull the surface of the jewelry.  By evaporating all moisture from the jewelry immediately with your hair dryer you also remedy the mineral dulling problem.

Birthstone Chart